|
[Sponsors] |
March 26, 2001, 07:15 |
Need how many iteration times
|
#1 |
Guest
Posts: n/a
|
Hi,Mr or Mrs:
I'm modeling laminar flame(methane/air).I considered laminar flow, radiation(fluid and solid), chemical reaction.Probably, because the problem is comlex(too many sub-model),no convergence is obtained even if the computer iterates for more than 10,000 times(I note that several handred of iteration time is needed in many FLUENT tuterial guides).Can you tell me that so many iteration times is correct or not? Thank you very much! Sincerely yours, Harry. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
benchmark: flow over a circular cylinder | goodegg | Main CFD Forum | 12 | January 22, 2013 11:47 |
PEM fuel cell long iteration times | inoxrocks | FLUENT | 2 | August 7, 2012 07:36 |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
Parallel runs slower with MTU=9000 than MTU=1500 | Javier Larrondo | FLUENT | 0 | October 28, 2007 22:30 |
Heat exchanger problem | chiseung | FLUENT | 16 | October 20, 2001 04:36 |