|
[Sponsors] |
June 26, 2002, 15:31 |
Cooper hard-linked faces
|
#1 |
Guest
Posts: n/a
|
Hello. A Gambit question.
Is it possible to cooper a volume in which the source faces are hard-linked? I meshed the edges (put node points), applied a boundary layer, meshed the source face, and it will not work when I HEX/Cooper the volume. I get an error message stating "ERROR: The matching of existing meshes on opposite ends of a sweep failed." Any help would be greatly appreciated. Sincerely, Eric R. |
|
June 27, 2002, 15:54 |
Re: Cooper hard-linked faces
|
#2 |
Guest
Posts: n/a
|
Hi Eric,
Unfortunately the answer is no. You have to leave at least one of the source faces unmeshed to use cooper scheme and when you have hardlinked all of the source faces it is impossible to use cooper scheme.You have to break hardlinks between source faces. Good Luck, |
|
June 27, 2002, 16:20 |
Re: Cooper hard-linked faces
|
#3 |
Guest
Posts: n/a
|
Thank you Mustafa. I was afraid that would be the case. At least now I can now try alternate approaches. Thank you for responding, as I've been spending a few days trying to get around this.
Regards, Eric |
|
June 28, 2002, 07:24 |
Re: Cooper hard-linked faces
|
#4 |
Guest
Posts: n/a
|
Hi Eric,
Probably you do not need alternate approaches. You can overcome this situation by unlinking the source faces meshes. Regards, Mustafa |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |