 |
 |
 |
|
|
|
[Sponsors] | ||||
February 16, 2003, 02:14
|
free surface problem PLEASE HELP ME
|
#1 |
|
Guest
Posts: n/a
|
hello dear friend i have two problem with VOF 1-how can i give profile of velocity in velocity inlet to fluent. 2-i have two phase,air and water in an open channel,depth of water in channel is about 0.3m and the depth of channel is 0.5m,please tell me how i can specify water fractionin inlet and outlet(inlet has velocity inlet and outlet has pressure outlet boundary condition. thanks bye
|
|
|
||
|
February 17, 2003, 06:07
|
Re: free surface problem PLEASE HELP ME
|
#2 |
|
Guest
Posts: n/a
|
When you have vel. inlet and two phases you should make two, boundaries for your inlet. this would help you..
|
|
|
|
||
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 38 | March 6, 2013 16:47 |
| CFX convergence issues with free surface | adenlan | CFX | 3 | September 2, 2011 06:43 |
| Linear analytical solution oto the 2D free sloshing water surface elevation | bearcat | Main CFD Forum | 7 | August 5, 2011 20:13 |
| [ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 0 | August 5, 2011 16:02 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
