|
[Sponsors] |
March 7, 2003, 08:33 |
Floating point?
|
#1 |
Guest
Posts: n/a
|
Hello everyone, When I use fluent to simulate 3D flow field, the following error appears: the floating point. What's the meaning? And what should I do? Thank you!
|
|
March 10, 2003, 06:25 |
Re: Floating point?
|
#2 |
Guest
Posts: n/a
|
I had the same error in 2D simulation. Try to change under-relaxation factors and if it is unsteady problem maybe time step is to large.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MPI Error - simpleFoam - Floating Point Exception | scott | OpenFOAM Running, Solving & CFD | 3 | April 13, 2012 16:34 |
block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
reactingFoam floating point exception | pajofego | OpenFOAM | 0 | November 6, 2010 17:29 |
floating point exception? | syd | STAR-CCM+ | 3 | April 20, 2010 18:55 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |