|
[Sponsors] |
April 6, 2003, 07:46 |
Gambit question
|
#1 |
Guest
Posts: n/a
|
Hi,
I am modelling a cyclinder heat sorce in a rectangular room. But I can form grid in the region of heat souce. Since I can form a whole volume about these two volumes by using gambit. It would be great anyone of you who is reading this can answer my question. Thanks, Li Y |
|
April 6, 2003, 15:49 |
Re: Gambit question
|
#2 |
Guest
Posts: n/a
|
Hi Li
Could you please rewrite your question it is very unclear your problem! Regards Alex |
|
April 6, 2003, 16:59 |
Re: Gambit question
|
#3 |
Guest
Posts: n/a
|
Li, As far as I understood that you face problem in solid ( heat source) and fluid ( air in room )meshing.. First of All, both volumes should exist..Check volume unite command options you used. From gambit you have to define the continium succefully. good luck Ahmed
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit maillage question | stage81 | FLUENT | 0 | October 1, 2010 10:06 |
Gambit question. | Pablo Cornejo | FLUENT | 10 | March 10, 2006 09:46 |
Gambit question | xiang | FLUENT | 0 | April 29, 2003 22:02 |
a question about Gambit | Jack | FLUENT | 5 | February 6, 2003 06:04 |
an easy question about gambit | brian | FLUENT | 3 | December 2, 2002 23:58 |