|
[Sponsors] |
March 26, 2004, 12:09 |
Reversed flow
|
#1 |
Guest
Posts: n/a
|
Hi I want vacate a bulb . my boundary condition is pressure outlet. backpressure is 1000Pa and backflow total tempreture is 320k. I received this message when start iteratetion. reversed flow in .... faces on pressure_outlet.... Is my boundary condition selection correct? tank yuo. amir
|
|
March 26, 2004, 14:17 |
Re: Reversed flow
|
#2 |
Guest
Posts: n/a
|
Usually this message is not a problem. FLUENT just tells you there's an inversion in the direction of the flow at the boundary. Sometimes it can cause convergence problem.
Hi ap |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
reversed flow | free | FLUENT | 4 | February 27, 2014 01:56 |
reversed flow during RNG in turbulence-k epsilon | Suman Kandula | FLUENT | 4 | April 2, 2012 07:12 |
Reversed flow...>>>Please HELP...! | sushii | FLUENT | 14 | October 29, 2007 04:27 |
reversed flow at velocity inlet / mass flow inlet | ib | FLUENT | 1 | March 26, 2007 13:11 |
reversed flow | Sastry | FLUENT | 5 | March 22, 2007 08:05 |