 |
 |
 |
|
|
|
[Sponsors] | ||||
March 26, 2004, 13:09
|
Reversed flow
|
#1 |
|
Guest
Posts: n/a
|
Hi I want vacate a bulb . my boundary condition is pressure outlet. backpressure is 1000Pa and backflow total tempreture is 320k. I received this message when start iteratetion. reversed flow in .... faces on pressure_outlet.... Is my boundary condition selection correct? tank yuo. amir
|
|
|
||
|
March 26, 2004, 15:17
|
Re: Reversed flow
|
#2 |
|
Guest
Posts: n/a
|
Usually this message is not a problem. FLUENT just tells you there's an inversion in the direction of the flow at the boundary. Sometimes it can cause convergence problem.
Hi  ap |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| reversed flow | free | FLUENT | 4 | February 27, 2014 02:56 |
| reversed flow during RNG in turbulence-k epsilon | Suman Kandula | FLUENT | 4 | April 2, 2012 08:12 |
| Reversed flow...>>>Please HELP...! | sushii | FLUENT | 14 | October 29, 2007 05:27 |
| reversed flow at velocity inlet / mass flow inlet | ib | FLUENT | 1 | March 26, 2007 14:11 |
| reversed flow | Sastry | FLUENT | 5 | March 22, 2007 09:05 |
Linear Mode
