|
[Sponsors] |
September 24, 2004, 13:24 |
POROUS LAYER
|
#1 |
Guest
Posts: n/a
|
Hi!!! I have a very thin porous layer, between two fluid zones in which there are different species, how could I stop the passing of every species through the layer?
P.S:I think I can't use porous jump because I've to define UDSs in the layer for solving my model. Thanks in advance!!! Ari |
|
September 24, 2004, 14:13 |
Re: POROUS LAYER specification
|
#2 |
Guest
Posts: n/a
|
In fluid zones there are only gaseous species, while in the layer there is one liquid species.
|
|
September 26, 2004, 01:11 |
Re: POROUS LAYER specification
|
#3 |
Guest
Posts: n/a
|
your are confiused still with your self, try again you will get it.
good luck sanjay |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
Moving Porous Layer | Josh | FLUENT | 0 | July 9, 2007 14:20 |
can fluent capture BOUNDARY LAYER of POROUS zone? | Alex | FLUENT | 0 | April 22, 2006 07:14 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |