|
[Sponsors] |
December 22, 2005, 05:04 |
Help: Negative Volume
|
#1 |
Guest
Posts: n/a
|
I have constructed a model of the furnace. In this when i mesh one of the volume and then summarize the meshed volume then it shows that the meshed volume is negative volume. Please tell me the way to remove the negative volume.Does this negative volume has any effect when i export the model in Fluent and carry out the analysis over there. Thank you
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
On the damBreak4phaseFine cases | paean | OpenFOAM Running, Solving & CFD | 0 | November 14, 2008 21:14 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |