CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > FLUENT

Error in meshing

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   January 5, 2006, 03:04
Default Error in meshing
  #1
Mannsonu
Guest
 
Posts: n/a
Hello While meshing following error comes. Initilization failed to mesh nodes. ERROR:TG_mehs_Domain failed with error code 1 ERROR:Tetrahedral meshing has failed for volume 35 This is usually caused by problem in the face mesh.Check the slewnesses of your face mesh and make sure the face mesh sizes are not too large in areas of small gaps. Please give the solution to remove the above error. Thanking you Mannsonu

  Reply With Quote

Old   January 6, 2006, 01:47
Default Re: Error in meshing
  #2
sharuk
Guest
 
Posts: n/a
check ur edge mesh setting and then do face mesh and check if any large gaps r there or not.
  Reply With Quote

Old   January 6, 2006, 02:03
Default Re: Error in meshing
  #3
MannSonu
Guest
 
Posts: n/a
Thanks, In my problem there is a container of 1800*3700*2400mm and in that there is sheet of 0.672mm thicknes and 770 mm width and 1300 height. i first subtracted the sheet from container. and then meshing then above meshing problem given

From MannsSonu
  Reply With Quote

Old   January 6, 2006, 04:46
Default Re: Error in meshing
  #4
sharuk
Guest
 
Posts: n/a
since ur sheet is very thin(compared to other dimensions), give a proper interval size to ur sheet thikness and proceed, else use size function,
  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing David-CFD ANSYS Meshing & Geometry 1 April 1, 2011 05:22
Best Meshing scheme for Cylinder Nutrex Main CFD Forum 4 July 29, 2008 11:03
Meshing locks workbench window. andy2o CFX 0 February 1, 2008 06:01
Singularity of grid?Volume meshing vs face meshing Ken Main CFD Forum 0 September 4, 2003 11:09
Volume Meshing & Face Meshing? singularity of grid ken FLUENT 0 September 4, 2003 11:08


All times are GMT -4. The time now is 17:30.