Problems in boundary layer meshing -- CFD Online Discussion Forums

February 17, 2006, 14:40	Problems in boundary layer meshing	#1
Henriques Guest Posts: n/a	Hi all, I am using boundary layer in GAMBIT to create a dense mesh near the wall. I am getting following error messeage: Warn: Mesh sizes on the face channel is is smaller than geometric tolerences. Use larger mesh sizes or larger geometry. What could be the mistake. I have tried many combinations of boundary layer parameters and also meshing of edges. But same warning. Thanks

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[GAMBIT] Boundary layer meshing problems	gambiss	ANSYS Meshing & Geometry	19	February 9, 2011 06:58
Inflation layers / boundary layer meshing.	andy2o	Main CFD Forum	3	February 22, 2009 09:03
* Guidelines on Boundary Layer Meshing *	Carlos	FLUENT	3	March 19, 2008 08:29
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15
Boundary layer simulation - convergence problems	Gavin Tabor	Main CFD Forum	3	July 2, 2004 05:16

All times are GMT -4. The time now is 14:05.