|April 18, 2006, 03:25||
Fluent 2D Model - Axial Fan in a Duct
I want to model axial fan which is located in a duct. Fan characteristics (Ie Static Pressure Vs Flow rate) is known (From Fan manufacturers data).
The Duct is 5 meter long (Each side 0.5 meter, square section) and fan is located at 3meters from the Inlet.
Duct Inlet is at atmospheric pressure and outlet air discharge to atmosphere.
Could any one let me know how to define Boundary conditions and fan characteristics (both Static presure and Flow rates)in Fluent modelling.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Fluent setup to determine fan performance||afaik||FLUENT||5||August 1, 2014 05:27|
|[ICEM] domain interface in ICEM for fluent||hsn||ANSYS Meshing & Geometry||24||November 27, 2012 17:43|
|Reynolds Stress Model in Fluent Vs CFX||Tim||FLUENT||0||December 6, 2005 23:03|
|modelling fuel cell duct in fluent||rajesh kumar tippabhotla||FLUENT||2||October 7, 2004 13:04|
|Question about flow in ducted fan in another duct||Jane||FLUENT||0||June 21, 2004 14:57|