|
[Sponsors] |
May 13, 2006, 12:30 |
Couldn't re-open a fluent case
|
#1 |
Guest
Posts: n/a
|
Hi Fluent user, I have my case and data file iterated until for some time then I save them using write 'case and data' in GUI. Sooner after that I couldn't re-open the file and it give me the error message as shown below. For your information the grid innitially 'fail' but I have fixed them using TUI (modify-zones/repair-face-handedness) before solving the problem. The grid itself contain 3 pairs of interface surface. I've face a similar problem before with a half-domain (simplified) grid and tought that it might go away if I model a full domain, anyway the problem is still persist. I suppose someone migh face the similar problem before, so I'm looking forward for your suggestion about this issue. Thanks in advance.
Error message ------------------------------------------------------ Building... grid, Cell Centroid is xc 0.014587 yc 0.000032 zc 0.002573WARNING: no face with given nodes. Thread 3, cell 45412 Error: Build_Grid: grid error. Clearing partially read grid. Error: Null Domain Pointer Error Object: () |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to open Icem mesh in Ansys Fluent? | emmkell | FLUENT | 27 | February 6, 2018 03:34 |
Time to open Fluent from Workbench | ResH | FLUENT | 0 | September 30, 2010 02:11 |
Executing Fluent case in OpenFOAM | Viglen1956 | OpenFOAM | 0 | June 7, 2010 06:47 |
How to open two case in paraview? | bowlderyu | OpenFOAM | 2 | June 2, 2009 04:20 |
Open more than one file in FLUENT. | L3munoz | FLUENT | 4 | April 14, 2009 05:39 |