|
[Sponsors] |
June 2, 2006, 06:05 |
Setting Fluent Problem
|
#1 |
Guest
Posts: n/a
|
Hi , i am doing a project and the first step is benchmarking: for this we have to find drag coefficient C_d for Re=100 over cylinder of diameter 10 mm, i have created the mesh, and after solving after 100-200 iteration where convergence crtiera is met, the results are quite different from the experimental result can someone pls explain it.
Or how do i set up conditions in Fluent for the above problem of cylinder |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fluent convergence problem | josip76 | FLUENT | 0 | May 26, 2011 20:08 |
[ICEM] [FLUENT] 2D Geometry problem when exporting to Fluent - Unwanted walls | MikeTichondrius | ANSYS Meshing & Geometry | 1 | February 9, 2011 13:31 |
problem about periodic boundary condition in Fluent | winnawinna | FLUENT | 0 | December 28, 2010 23:32 |
Problem about Fluent on Linux | hbinma | FLUENT | 3 | July 6, 2008 10:49 |
UDF problem caused by various version of Fluent | Yurong | FLUENT | 3 | January 15, 2006 10:57 |