|
[Sponsors] |
UDF problem caused by various version of Fluent |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 13, 2006, 06:24 |
UDF problem caused by various version of Fluent
|
#1 |
Guest
Posts: n/a
|
Hi,
I come across a problem which maybe caused by various version of FLuent. The former udf was used in Fluent 6.1. When I use these udf in Fluent 6.2, error information appears as followed "Error: FLUENT received fatal signal (ACCESS_VIOLATION) 1. Note exact events leading to error. 2. Save case/data under new name. 3. Exit program and restart to continue. 4. Report error to your distributor. Error Object: ()" I can interpreted these udf but cannot use them just due to these error. Could you please tell me what is the possible reasons for this? Thanks in advance. Yurong |
|
January 13, 2006, 09:55 |
Re: UDF problem caused by various version of Fluen
|
#2 |
Guest
Posts: n/a
|
i also meet this question. it is caused by any UDF error. you should look carefully over your UDF codes. bear in mind: carefully!!
|
|
January 13, 2006, 11:55 |
Re: UDF problem caused by various version of Fluen
|
#3 |
Guest
Posts: n/a
|
I have had similar problems. My Fluent support engineer was able to trace one instance back to reading saved boundary conditions in over a new geometry - and apparent differences in V6.1 and V6.2. I still have a problem doing pathlines in 6.2, when the same UDFs were fine in 6.1. No answer for this one.
I don't necessarily think it is a problem with my UDFs - only that 6.1 and 6.2 treat them with subtle differences. More specifically, what problems are you having? |
|
January 15, 2006, 10:57 |
Re: UDF problem caused by various version of Fluen
|
#4 |
Guest
Posts: n/a
|
Thank you all for your attention for my question.
Thanks haitao_zhang for your suggestion and I will check my udf codes carefully. Allan, my udf is for porosity distribution, inertical resistance factor and viscous resistance factor in porous media. I haven't solved this problem. I want to cry~ |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ATTN ALL: SOLUTON TO UDF COMPILE PROBLEM | Rizwan | Fluent UDF and Scheme Programming | 40 | March 18, 2018 06:05 |
OpenFOAM-1.6 install cookbook | MadsR | OpenFOAM Installation | 372 | November 20, 2010 11:57 |
what's the problem with my udf | zzyan | FLUENT | 0 | November 4, 2010 03:56 |
UDF using problem, error happens-heip!! | Michael | FLUENT | 1 | December 9, 2008 07:51 |
Fluent New Version 6.3 Problem Help!!!! | phinix | FLUENT | 1 | March 15, 2007 20:16 |