Unwanted Wall Boundaries for 3D geometries

July 27, 2006, 00:41

When I create a 3D geometry in Gambit and then display the grid Fluent, a wall boundary usually appears that I did not create in Gambit. It will often be named "wall" and it consists of interior faces. I cannot figure out how to delete these walls in Fluent or how to change them to a boundary type that does not impede flow.

July 27, 2006, 01:39

Sounds like a mistake made in gambit. You should have a look if the two volumes where the wall appears are conected to each other. hope that helps.

July 27, 2006, 00:41	Unwanted Wall Boundaries for 3D geometries	#1
Cappy Guest Posts: n/a	When I create a 3D geometry in Gambit and then display the grid Fluent, a wall boundary usually appears that I did not create in Gambit. It will often be named "wall" and it consists of interior faces. I cannot figure out how to delete these walls in Fluent or how to change them to a boundary type that does not impede flow.

July 27, 2006, 01:39	Re: Unwanted Wall Boundaries for 3D geometries	#2
Gernot Guest Posts: n/a	Sounds like a mistake made in gambit. You should have a look if the two volumes where the wall appears are conected to each other. hope that helps.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
help with wall functions	Nick Georgiadis	Main CFD Forum	10	January 17, 2017 10:03
UDF for wall slipping	HFLUENT	Fluent UDF and Scheme Programming	0	April 27, 2011 12:03
How i can create a wall with out boundaries???	STK	FLUENT	1	July 7, 2004 13:20
Wall function in adverse pressure gradients	stephane baralon	Main CFD Forum	11	September 2, 1999 04:05
Wall functions	Abhijit Tilak	Main CFD Forum	6	February 5, 1999 01:16