|
[Sponsors] |
January 20, 2007, 05:12 |
Aspect ratio vs boundary layer
|
#1 |
Guest
Posts: n/a
|
Hi! Everyone Someone told me in order to obtain good converged results I need to keep the grid aspect ratio low too. But how about at the boundary layer? A.R usually high at the boundary layer.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Automobile aero ground boundary layer OR simpleFoam/GAMG and high aspect ratio cells | kyle | OpenFOAM Running, Solving & CFD | 4 | January 4, 2011 11:17 |
[GAMBIT] Viscous layer elements aspect ratio | siw | ANSYS Meshing & Geometry | 0 | September 29, 2009 05:10 |
CREATION OF BOUNDARY LAYER | Jibran Haider | FLUENT | 3 | August 1, 2008 00:33 |
GAMBIT problem with 3D Boundary Layer when meshing | Anthony Haroutunian | FLUENT | 2 | March 26, 2008 02:02 |
New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |