|
[Sponsors] |
April 9, 2007, 11:46 |
BLayer
|
#1 |
Guest
Posts: n/a
|
Hello, I'm trying to attach a BL mesh to a surface but the arrow points out of the domain volume and therefore it is improperly attached. Ho to make the arrow pointing into the volume? thanks
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM 2D tetra mesh question | kawamatt2 | ANSYS Meshing & Geometry | 18 | March 3, 2014 10:56 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
[ICEM] Can’t get 2D Blayer in hex mesh to be accurate O-block around airfoil | josip76 | ANSYS Meshing & Geometry | 2 | June 4, 2011 18:03 |