|
[Sponsors] |
July 9, 2007, 14:20 |
Moving Porous Layer
|
#1 |
Guest
Posts: n/a
|
Hi
I am modeling roughness in a microchannel by using a porous layer at the wall. I have set up a UDF that defines this layer and it works fine. I would now like to create a model that implements roughness and slip boundary by having just the porous layer move based on the following, F_PROFILE(f,thread,index)=fabs((1e-7)*C_U_G(c,cell_thread)[1]); which is of the form: Kn*H*du/dy Is there a way to do this? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to set boundary layer of a moving body in GAMBIT to a mesh zone for dynamic mesh | tomyangbath | FLUENT | 18 | October 12, 2016 06:57 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
How to make boundary layer mesh moving with wall | wayne | FLUENT | 3 | June 11, 2008 23:23 |
can fluent capture BOUNDARY LAYER of POROUS zone? | Alex | FLUENT | 0 | April 22, 2006 07:14 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |