|
[Sponsors] |
July 26, 2007, 06:12 |
plotting on the edge of a face
|
#1 |
Guest
Posts: n/a
|
Hello,
I have specified a face in Gambit as 'wall'. I want to plot static pressure at one of the edges. How can i do it in Fluent. The face constitutes part of a volume. Thank you. |
|
July 26, 2007, 17:33 |
Re: plotting on the edge of a face
|
#2 |
Guest
Posts: n/a
|
Hey
First, You have to know the coordinates (x, y, z) of the two verices (end points) of that edge. You can get them from Gambit (there are other ways to specify a line (check the manual), but I find this the easiest). Then, in Fluent, Go to "Line/Rake" and insert the coordinates of the two end points. If you want the pressure values at the center of each cell, choose line (they might not be equally speced though if your grid is not uniform in that direction), or choose rake and specify the number of data points you want (they will be equally spaced). Then go to "plot", "xy plot, and choose Pressure for the y function and your line/rake for the x function. Good Luck AAA |
|
July 27, 2007, 05:18 |
Re: plotting on the edge of a face
|
#3 |
Guest
Posts: n/a
|
HI,
Thank you for your help. Will this method work for a curved edge as well. Thanks, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |