|August 10, 2007, 04:12||
How to set up the B.C. for LNG gas
I'd like to simulate LNG gas in 3D pipe with the by-pass line.
The geometry is a quite simple - just 2 short pipes (4 m length). those pipelines are connected bypass line (a kind of W shape)
I want to know how much pressure on the elbow part of bypass line
But, I only know the inlet pressure - 60 bar (6Mpa).
How do I set up the inlet BC? also How to define the LNG gas in FLUENT?
Do I need other variables?
Please let me know any ideas for this problem.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Calculation of the Governing Equations||Mihail||CFX||7||September 7, 2014 06:27|
|OpenFOAM on MinGW crosscompiler hosted on Linux||allenzhao||OpenFOAM Installation||127||January 30, 2009 20:08|
|Problems with installation of OpenFoam||sheyer||OpenFOAM Installation||8||July 28, 2008 03:45|
|OpenFOAM installation on SUSE92 problems||derath||OpenFOAM Installation||1||April 3, 2006 06:44|
|How to set environment variables||kanishka||OpenFOAM Installation||1||September 4, 2005 10:15|