|
[Sponsors] |
April 15, 2008, 04:52 |
Fluent not creating Shadow wall
|
#1 |
Guest
Posts: n/a
|
Hi everyone,
I imported the mesh (in FLUENT)of Francis turbine (hydro turbine),which consist of three fluid zones correspond to Casing, runner and draft tube respectively. But FLUENT does not show any shadow walls between different components, though the mesh of different components are different and not fused with each other. Please reply me as early as posible. Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
match uds boundary condition in wall & wall-shadow | pour | FLUENT | 0 | May 20, 2008 08:56 |
Shadow Wall | Soheyl | FLUENT | 1 | March 12, 2008 13:45 |
Fluent Not creating shadow wall | Celine Garnier | FLUENT | 1 | September 10, 2007 13:02 |
wall & wall shadow net heat flux | Barbaros | FLUENT | 1 | August 5, 2006 02:00 |
Fluent creating wall zone on mesh import? | Mark | FLUENT | 4 | April 4, 2005 07:14 |