|
[Sponsors] |
June 9, 2008, 00:45 |
Drag coefficient and inlet problems
|
#1 |
Guest
Posts: n/a
|
Hey, i am modelling unsteady flow past a circular cylinder and when i run the analysis initially i should get a cd value of zero. However this is not what i am geting even though the results look correct after this initial error. Does anyone have any suggestions? I have modelled the problem with a velocit inlet.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fluent Good Lift coefficient BAD drag coefficient | Rif | Main CFD Forum | 4 | March 9, 2010 11:52 |
coefficient of drag(Cd) | haris | FLUENT | 8 | January 11, 2008 00:25 |
Drag Coefficient | Julian | CFX | 8 | May 25, 2006 08:40 |
drag coefficient problems | Mike | FLUENT | 0 | September 8, 2005 16:59 |
about the drag coefficient | maximus | Main CFD Forum | 7 | April 18, 2005 20:00 |