|
[Sponsors] |
HOW TO APPLY CONSTANT HEAT FLUX OVER WALL OF TUBE |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 23, 2009, 00:54 |
HOW TO APPLY CONSTANT HEAT FLUX OVER WALL OF TUBE
|
#1 |
Guest
Posts: n/a
|
sir, i'm doing my master's degree project in cfd,my project is dealing with internal tappered finned tube,i use to model by gambit and analyse by fluent. my boundary condition is constant heat flux over the entire wall surface,inlet temperature and inlet velocity,laminar flow. for applying heat flux over the wall i have little bit confusion, Because while i modeling i modelled only fluid flow area,suppose if i apply heat flux value means it takes value same as outer region as well as internal finned area. plz kindly send help tutorial for internal tappered finned tube as well as your kind suggesion..
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
constant heat flux BC | sunny | Main CFD Forum | 3 | January 21, 2005 10:03 |
Constant heat flux | ocy | FLUENT | 1 | January 17, 2005 01:54 |
constant Heat flux at the wall | hatta | FLUENT | 2 | January 9, 2004 07:13 |
Constant wall heat flux with uniform temperature | Jake | FLUENT | 2 | September 29, 2003 11:34 |
How to apply heat flux condition | L. Zhu | FLUENT | 2 | January 8, 2003 10:16 |