 |
 |
 |
|
|
|
[Sponsors] | ||||
January 6, 2010, 08:34
|
L-shaped duct
|
#1 |
|
Senior Member
Sebastian Gatzka
Join Date: Mar 2009
Location: Frankfurt, Germany
Posts: 729
Rep Power: 20  |
Hello world.
I'm trying to simulate the flow in an L-shaped duct. See the picture attached. I'm using velocity-inlet and outflow as boundary conditions. The rest are walls. Unfortunately the case does not converge. Residuals are stuck at some level. On what does the convergence of such a case depend? Any ideas?
__________________
Schrödingers wife: "What did you do to the cat? It's half dead!" |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| S shaped duct | francois | Main CFD Forum | 5 | May 16, 2014 05:44 |
| Fabric Duct Modeling | Dan | FLUENT | 0 | June 30, 2008 15:00 |
| Total pressure increase in the diverging duct | shiv | Siemens | 3 | February 1, 2008 03:39 |
| modelling fuel cell duct in fluent | rajesh kumar tippabhotla | FLUENT | 2 | October 7, 2004 12:04 |
| flow simulation across a small fan | jane luo | Main CFD Forum | 15 | April 12, 2004 17:49 |
Threaded Mode
