|
[Sponsors] |
February 3, 2010, 06:40 |
Fluent 12
|
#1 |
New Member
Reuven
Join Date: Feb 2010
Posts: 4
Rep Power: 16 |
Hello,
Do i need GAMBIT in order to create a mesh in Fluent 12? If not, how can I do that in Fluent 12? thanks |
|
February 3, 2010, 07:38 |
|
#2 |
Member
Newton KF
Join Date: Mar 2009
Posts: 36
Rep Power: 17 |
Hi Robi... no, you don't need Gambit... you may use ICEM to do the mesh... And, I think, you may also use the workbench to do non-complex meshes...
Good luck... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 06:24 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |
Run Fluent in batch mode | Shengping LUO | FLUENT | 2 | October 24, 2000 05:42 |