|
[Sponsors] |
April 21, 2010, 07:33 |
Mass flow rate: calculation v/s computation
|
#1 |
New Member
Annon
Join Date: Apr 2010
Posts: 18
Rep Power: 16 |
Hi all,
In my simulations density (Rho) is constant. I have computed mass flow rate (M) through an interior face using standard mass flow rate calculation option from fluent. Then I calculated mass averaged velocity (Vm), area weighted averaged velocity (Va) and facet averaged velocity (Vf). To recheck, I calculated the mass flow rate as M' = Rho*A*V. By using all the three above mentioned velocities in the above formula I am not able to get both mass flow rates the same (i.e. M' and M are not equal). Which is the apropriate value of velocity that one should consider to re-calculate accurately the mass flow rate? I guess, the mass flow rate is computed in fluent as summation of (Rho*A*V) values at all the facets. Could any body throw some light on this issue? Thanks. -aditya |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF to measure Mass Flow Rate | a.lynchy | Fluent UDF and Scheme Programming | 31 | October 4, 2018 14:10 |
The reporting of mass flow rate | summer | FLUENT | 1 | July 12, 2007 09:35 |
mass flow rate error | Masood | FLUENT | 0 | May 22, 2005 00:32 |
Target mass flow rate | Saturn | FLUENT | 0 | December 10, 2004 04:18 |
Mass flow rate | Neser | CFX | 4 | February 14, 2004 00:27 |