|
[Sponsors] |
How to know the lenght of an edge with Design modeler |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 27, 2011, 09:19 |
How to know the lenght of an edge with Design modeler
|
#1 |
New Member
Join Date: Apr 2011
Posts: 3
Rep Power: 15 |
Hi,
Is it possible to perform a very simple operation with Design Modeler: to measure the lenght of an edge. I've been trying for an hour. I miss gambit.... |
|
April 27, 2011, 11:34 |
|
#2 |
Member
jonathan
Join Date: Jun 2009
Posts: 47
Rep Power: 17 |
In design modeler click on the "Tools" menu toolbar item. Then click on "Analysis Tools". Under that sub menu item is "Entity Information". Click on this and then then select the feature (edge, face, body) of interest to see geometry information. Make sure your selection filter is set to edges so that design modeler singles out your edges only.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Connecting 3D bodies in Ansys Design Modeler | chipper | ANSYS Meshing & Geometry | 4 | January 25, 2018 09:45 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 10:18 |