|August 3, 2011, 05:05||
could you help me about "moving boundary layer" ?
Join Date: Aug 2011
Posts: 3Rep Power: 7
1)i have got a cylinder with thickness of 1cm and its closed from one side and we put one hot fluid in it and its getting cooled by time and gets solid from r=R and i have got a boundary layer which moves near the center. i dont know how to enter it to fluent.
this system is at t=0 at 150degree and that fluid changes to solid at 120 degree.
2)and i entered my boundary conditions and i want to know are they correct or
3)is the thickness of wall from our pressure inlet ?
4)if we want to mesh the fluid we HAVE TO define a face for that?(i mean i emptied the cylinder and now i cant mesh the fluid)
please help me...ITS ERGENT....
my email: firstname.lastname@example.org
|Thread||Thread Starter||Forum||Replies||Last Post|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|CFX doesn't continue calculation...||mactech001||CFX||6||November 15, 2009 22:25|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|Boundary conditions?||Tom||Main CFD Forum||0||November 5, 2002 02:54|
|Boundary Conditions||Jan Ramboer||Main CFD Forum||11||August 16, 1999 08:59|