|October 26, 2011, 08:15||
How to carry out 3D shell and Tube Heat Exchanger analysis in fluent
Join Date: Oct 2011
Posts: 1Rep Power: 0
Please urgently, how to simulate heat exchanger in fluent? do i have to build a model in gambit first? or there is a settled model in fluent, because I done the following :
Choosed 3d version
Selected Define ---- User-Defined --- but I found Heat exchanger not active
I logged to chapter 7.25 of heat exchanger models and chapter 33.3 of user defined for heat exchanger in fluent help but I couldn’t activate the heat exchanger option.
They said I have to make a boundary condition file by (file ---- write-bc) but I couldn’t find this option also to make (define ---- user-defined ---- heat-exchanger) but also it gave me invalid command.
So please advice do I have to make heat exchanger model in gambit first or use fluent directly and how?
|December 30, 2015, 05:28||
Join Date: Dec 2015
Posts: 3Rep Power: 2
me also working on shell and tube heat exchanger, have you got the answer??
i modified the shell and tube heat exchnager, can i use inbuilt model of heat exchanger which is available in fluent?
I have two hot fluid an one cold fluid how can i apply this condition to the fluent model??
i also found the different boundary condition for all the wall of tube baffle and tubesheet,can i done by applying name section to all the part and than give the condition to all this in one point but all the part show individual in boundary condition?
Can anyone know whats the shadow?? in bc??
|Thread||Thread Starter||Forum||Replies||Last Post|
|Shell-and-tube heat exchanger||Andytzki||FLUENT||0||February 14, 2011 16:22|
|FSI error ERROR #001100279(Shell & Tube heat exchanger)||Chandrashekhar||CFX||3||March 26, 2010 16:04|
|3D shell and tube heat exchanger||Peter Jansen||FLUENT||2||June 7, 2006 07:01|
|Need for modeling heat exchanger in fluent||shashidhar||FLUENT||2||May 11, 2006 02:35|
|How to simulate 3D shell and Tube heat Exchanger||san||FLUENT||2||February 22, 2006 06:44|