|
[Sponsors] |
January 6, 2012, 01:51 |
Skewed elements on KVLCC2 hull
|
#1 |
New Member
Terence Chung
Join Date: Dec 2011
Posts: 9
Rep Power: 14 |
Hi everyone. I'm meshing a ship hull on Gambit and having skewed elements on 6 faces of the hull. I have applied a curvature sizing function on the hull side and have tried various ways(eg. refining the curvature sizing function, splitted the faces with skewed elements) but they do not work so far. I have the screenshot of the mesh here. Suggestions/ reasons would be most welcome.
Thank you in advance! Terence Last edited by s7evin; January 6, 2012 at 02:59. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Overlapping elements | Anorky | ANSYS Meshing & Geometry | 6 | November 6, 2017 08:22 |
[ICEM] Skewed Elements at Trailing Edge. | mr_stoked | ANSYS Meshing & Geometry | 0 | September 30, 2010 07:44 |
[ICEM] Negative Volumes & 7 node HEXA elements | mr_stoked | ANSYS Meshing & Geometry | 1 | September 21, 2010 12:45 |
Problem with skew faces in simpleFoam... | HelloWorld | OpenFOAM | 7 | May 14, 2010 11:28 |
Penetrating elements in extruded mesh | Michael P | CFX | 2 | May 20, 2005 08:06 |