|
[Sponsors] |
mesh quality problems: maximum skewness larger than 0.98 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 26, 2012, 18:24 |
mesh quality problems: maximum skewness larger than 0.98
|
#1 |
New Member
Join Date: Jan 2011
Posts: 10
Rep Power: 15 |
Hi there. I am simulating a numerical wave tank with a chamber in it. I build the mesh with DM meshing, but when I run it in FLUENT, there is a warning
maximum cell skewness exceed 0.98 what is the problem that causes the warning? besides this warning, there are two other things, the maximum cell squish is 0.9655 and the maximum aspect ratio is 256.198 does it mean the mesh quality is low? how can I deal with these problems? thanks! Last edited by cth_yao; January 26, 2012 at 18:25. Reason: specify my question |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
early stall, poor convergence, and mesh quality | everest | CFX | 2 | May 12, 2010 16:27 |