|
[Sponsors] |
February 10, 2012, 18:00 |
problem with unwanted faces..
|
#1 |
New Member
|
when i am trying to connect two meshed volumes that have a common face for conection...(example the cilinder out surface mesh is the same as the hole of a rectangular meshed volume (both face meshes are identical )gambit creates a unwanted wall...
how can i fix that problem with Tgrid??? or what can i do to dissapear that unwanted face??? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem : "reversed flow in 77 faces on outflow 12." | aliamini | FLUENT | 15 | February 6, 2014 14:06 |
problem due to reconstructPar? | doubtsincfd | OpenFOAM | 0 | June 3, 2011 16:16 |
[ICEM] Problem with meshing (uncovered faces, can't export bocos) | hectordiaz | ANSYS Meshing & Geometry | 16 | May 13, 2011 06:36 |
Converting Virtual Faces to Real Faces in Gambit | gstraw | Main CFD Forum | 0 | June 19, 2009 07:11 |
Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |