I've just started using MISES for the analysis of the flow through a turbine cascade. Could anyone of you explain the meaning of the following error message,

"Array overflow. Increase IQX",

that I get during the grid initialization for the 'panel solution'?

Thank you in advance

Marco

more precisely, the error message is

"STOP WAKSET: Array overflow. Increase IQX"

Marco

IQX mast be a paramiter (if misses is in fortran)just increase it ! (your grid is larger than your arrey)

p.s. i thing !! i hope i did't confuse you..

[Reichstein]

Has this been figured out? I get the following message:
>>

Reading in coordinate file for: Vane 1

Coordinates read from file blade.v1

Blade 1: 178 points. Sharp leading edge.

File read error: stream.v1
Default 2-D X,R,B used.

File read error: loss.v1
Zero prescribed pressure loss assumed.

Calculating unit vorticity distributions ...

File read error: gridpar.v1
Default grid parameters used.

Generating panel solution ...

Sinl = 0.000 Sout = -0.528 Cy = 0.1112 Cx = 0.0302

Setting wake for blade 1
Setting inlet streamline for blade 1
INLSET: Array overflow. Increase IQX.

<<

PLEASE NOTE:
MISES is sold under a commercial license. I do not have access to the source code so I can't change any parameters (i.e. IQX) in the code. My only handle are control files - but I can't find IQX anywhere ...

[funmaker]

HI Reichstein,

check your blade.xxx file for identically blade pairs, like:

1.21 0.95
1.13 0.87
0.9 0.71
0.9 0.71
...
...

MISES can not handle this.

Greets