|
[Sponsors] |
April 9, 2007, 22:15 |
GAMBIT Help
|
#1 |
Guest
Posts: n/a
|
I have a single face with relvant node distribution. However, when i extrude this face (volume - sweep function) and cerate a mesh within this newly created volume, the node distribution is different on the upper most face. How do you maintain the same node distribution when creating a volume from an exisiting mesh. Thanks
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to open a saved Gambit File? | barkan | FLUENT | 5 | September 1, 2012 05:53 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |
between IDL Gambit and rhino, any help? | philip | FLUENT | 0 | June 23, 2005 12:08 |