|
[Sponsors] |
April 9, 2007, 22:15 |
GAMBIT Help
|
#1 |
Guest
Posts: n/a
|
I have a single face with relvant node distribution. However, when i extrude this face (volume - sweep function) and cerate a mesh within this newly created volume, the node distribution is different on the upper most face. How do you maintain the same node distribution when creating a volume from an exisiting mesh. Thanks
|
|
April 10, 2007, 04:27 |
Re: GAMBIT Help
|
#2 |
Guest
Posts: n/a
|
don't create the volume from the meshed face but from a face without a mesh. Then create a mesh on one of the 2 faces and extrude it through the volume(cooper tool). The easiest way to do this is link the 2 faces for meshing before you mesh the first one - then it copies this mesh to the other one. This isn't always required for cooper though- only really for tri elements.
Always remember - create the geometry then make the mesh/do the boundary conditions. hope this helps |
|
April 11, 2007, 02:43 |
Re: GAMBIT Help
|
#3 |
Guest
Posts: n/a
|
thanks heaps mate...it works! exactly what i was looking for
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to open a saved Gambit File? | barkan | FLUENT | 5 | September 1, 2012 05:53 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |
between IDL Gambit and rhino, any help? | philip | FLUENT | 0 | June 23, 2005 12:08 |