|
[Sponsors] |
September 14, 2016, 17:18 |
Blocking idealization - Sketces.
|
#1 |
Member
William
Join Date: Aug 2016
Posts: 56
Rep Power: 9 |
Hi,
I'm about to make a mesh for a wing profile and I would like your advice on the blocking. Here is a sketch from Matlab which I will export to DAT files. (Easyer to modify in Matlab and Farfield Scaled down) The wing has a blunt edge as seen in figure 1. Figure 1: Airfoil with a skewed blunt edge. I created a C shaped grid (see Figure 2), projected to be parallel to the blunt edge. Then I have 100% Orthogonality right to the airfoil. Figure 2: C-Shaped Farfield, projected parallel to blunt edge. Now I'm not sure what is the best strategy of blocking. In figure 3 I sketched what I've been thinking. But not sure if this is the best way doing it. Figure 3: Blocking draft. I'm not sure if I need the extra OGRID around the wing since I will match the mesh parameters of all edges. Yet I see it used in most of the tutorials I've seen. Any comments? Fell free to save down figure 2 and sketch your vision of blocking. Thanks in advance, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Blocking | wali | ANSYS Meshing & Geometry | 2 | September 8, 2014 14:19 |
[ICEM] Problem to load the blocking | biasilveira | ANSYS Meshing & Geometry | 2 | February 24, 2013 22:04 |
[ICEM] Blocking and Symmetry | BrolY | ANSYS Meshing & Geometry | 32 | August 24, 2012 03:13 |
[ICEM] Using Blocking with ICEM (infinite blocking lines appeared) | Touré | ANSYS Meshing & Geometry | 2 | August 5, 2012 17:27 |
[ICEM] Blocking strategy | BrolY | ANSYS Meshing & Geometry | 0 | July 22, 2010 04:46 |