|
[Sponsors] |
June 20, 2011, 04:21 |
Immerged Part
|
#1 |
New Member
Amine Fakhfekh
Join Date: Jun 2011
Posts: 13
Rep Power: 14 |
Hi, I have to do a simulation but i can't do it with ansys because i'm a new user of ANSYS V12,
So, it's about immerging a part in a liquid (like water, gazoline..) and this part is moving, i want to see the streamlines applied for the part, I whish that i was clear I want to know what's the procedure to do this, Thanks a lot |
|
June 20, 2011, 04:34 |
|
#2 |
Senior Member
Morteza
Join Date: May 2010
Location: Iran,Islamic Republic of
Posts: 161
Rep Power: 15 |
Amineh, unfortunately you were not so clear .
please explain more about the case. |
|
June 20, 2011, 04:55 |
|
#3 |
New Member
Amine Fakhfekh
Join Date: Jun 2011
Posts: 13
Rep Power: 14 |
Sorry, I have an underwater vehicle, and i want to do a hydordynamc test, this vehicle is moving with a constant velocity, i want to see the streamlines of the liquid with the vehicle and the forces,
I want to know how immerging the vehicle in the water and how aplying a velocity for this case. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to simulate the rotation of a solid part | Jiuan | FLUENT | 2 | July 10, 2010 02:54 |
icem hexa - load different blockings for each part of geometry??? | Catthan | ANSYS Meshing & Geometry | 2 | May 28, 2010 11:27 |
[ICEM] How to mesh part by part? | rikio | ANSYS Meshing & Geometry | 6 | February 24, 2010 19:19 |
How to output data from stationary part only? | Aerolex | FLUENT | 0 | November 16, 2009 22:46 |
Any other way of converting a multi part to a single part avoiding ANSYS Design Model | LusoMundo | ANSYS Meshing & Geometry | 1 | May 14, 2009 14:35 |