|
[Sponsors] |
June 20, 2011, 04:21 |
Immerged Part
|
#1 |
New Member
Amine Fakhfekh
Join Date: Jun 2011
Posts: 13
Rep Power: 14 |
Hi, I have to do a simulation but i can't do it with ansys because i'm a new user of ANSYS V12,
So, it's about immerging a part in a liquid (like water, gazoline..) and this part is moving, i want to see the streamlines applied for the part, I whish that i was clear I want to know what's the procedure to do this, Thanks a lot |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to simulate the rotation of a solid part | Jiuan | FLUENT | 2 | July 10, 2010 02:54 |
icem hexa - load different blockings for each part of geometry??? | Catthan | ANSYS Meshing & Geometry | 2 | May 28, 2010 11:27 |
[ICEM] How to mesh part by part? | rikio | ANSYS Meshing & Geometry | 6 | February 24, 2010 19:19 |
How to output data from stationary part only? | Aerolex | FLUENT | 0 | November 16, 2009 22:46 |
Any other way of converting a multi part to a single part avoiding ANSYS Design Model | LusoMundo | ANSYS Meshing & Geometry | 1 | May 14, 2009 14:35 |