 |
 |
 |
|
|
|
[Sponsors] | ||||
July 16, 2005, 23:07
|
one question about nearest wall distance
|
#1 |
|
Guest
Posts: n/a
|
If on the wall, there is inlet or outlet, when I calculate the nearest wall distance, this opening part cannot be treated as the wall, isnot it?
|
|
|
||
|
July 20, 2005, 02:32
|
Re: one question about nearest wall distance
|
#2 |
|
Guest
Posts: n/a
|
In general you may approximate a wall opening as a source or sink if the opening size is small. In any case, the concept of near-wall distance would help much, as I guess.
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 15:33 |
| Unit normal vector of nearest wall | l_r_mcglashan | OpenFOAM Programming & Development | 3 | May 13, 2014 17:06 |
| general question about wall distance in ICEM + CFX | Andy | CFX | 6 | February 28, 2013 01:44 |
| Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
| Wall distance | Student | Main CFD Forum | 2 | August 4, 2005 22:33 |
Linear Mode
