|
[Sponsors] |
January 7, 2014, 07:37 |
Hexpress: failed feature line recognition
|
#1 |
New Member
Tim Franke
Join Date: Mar 2009
Posts: 8
Rep Power: 17 |
Hello,
I came across a phenomena and I wonder if someone could tell a work around. Given a cube where one edge is not completely sharp since after half of the edge length the sharp edge runs over into a radius that increases from R=0 to R=max at the corner point. After importing as stl eleven edges a shown a feature lines but the single edge decribed above is absent, although I would expect to see a feature edge that covers half of the cube edge. From a feature angle point of view the featre edge should be there. Regards, Tim |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Foam::error::printStack(Foam::Ostream&) with simpleFoam -parallel | U.Golling | OpenFOAM Running, Solving & CFD | 52 | September 23, 2023 03:35 |
whats the cause of error? | immortality | OpenFOAM Running, Solving & CFD | 13 | March 24, 2021 07:15 |
simpleFoam parallel | AndrewMortimer | OpenFOAM Running, Solving & CFD | 12 | August 7, 2015 18:45 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |