|
[Sponsors] |
July 30, 2003, 07:44 |
switching from Fine5.3 to Fine 6.1
|
#1 |
Guest
Posts: n/a
|
I had a project under Fine5.3 with a computation (let's say computation 1). I duplicated this project and started it under Fine6.1. Then I ran a new computation using "computation 1" as initial solution.
I made exactely the same thing under Fine5.3 and the convergence history is different. If using Fine5.3 there is a perfect continuity with "computation 1", there is no continuity under Fine6.1 and the amplitude of the oscillations I had increased! I noticed some changes in the control_variables/expert_parameters. Some defaults values changed and there is new parameters like IRSMCH. These changes can be the cause of my troubles? Thank U. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Switching on LES in 2D mode of fluent | Josef Dubsky | FLUENT | 27 | March 16, 2016 13:49 |
3D axis switching in a turbulent jet | fluidsguy1001 | FLUENT | 0 | November 6, 2007 17:18 |
switching "ON" viscosity | Vishal | Siemens | 1 | October 10, 2005 06:28 |
Switching from Fluent to CFX | Terri Novotny | CFX | 1 | December 7, 2004 21:59 |
switching from build 2 ICEM CFD 4.CFX | bogesz | CFX | 4 | February 27, 2004 01:31 |