 |
 |
 |
|
|
|
[Sponsors] | ||||
July 26, 2007, 15:54
|
Has anybody tried using GCC 4.
|
#1 |
|
Guest
Posts: n/a
|
Has anybody tried using GCC 4.2.0 to compile OpenFOAM yet?
I will probably try it next weekend or the following weekend. If I can get a few good bench mark results, I'll post them. |
|
|
||
|
July 26, 2007, 17:14
|
We didn't find any difference.
|
#2 |
|
Senior Member
Mattijs Janssens
Join Date: Mar 2009
Posts: 1,419
Rep Power: 26  |
We didn't find any difference. You could try compiling with -ffast-math but that loses the floating-point overflow trapping (FOAM_SIGFPE).
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Is GUI there for OpenFoam | navaladi | OpenFOAM | 4 | September 11, 2023 13:35 |
| OpenFoam vs CFX5 mass balance in OpenFoam | tangd | OpenFOAM Running, Solving & CFD | 33 | May 23, 2010 16:36 |
| [blockMesh] CheckMesh error using a tutorial from OpenFOAM 114 with openFOAM 13 | martapajon | OpenFOAM Meshing & Mesh Conversion | 7 | January 21, 2008 12:52 |
| OpenFOAM users in Munich OpenFOAM benutzer in M%c3%bcnchen | jaswi | OpenFOAM | 0 | August 3, 2007 13:11 |
| A new Howto on the OpenFOAM Wiki Compiling OpenFOAM under Unix | mbeaudoin | OpenFOAM Installation | 2 | April 28, 2006 08:54 |
Linear Mode
