|November 21, 2012, 22:26||
Join Date: Sep 2012
Posts: 36Rep Power: 4
I just did some work with this.
I found a good way to prevent skew near the center is to mesh a square in the center and then two block on adjacent faces of the original block with arc'ed outer edges.
I assumed axi-symmetric geometry and only meshed 1/4 of the cylinder.
|Thread||Thread Starter||Forum||Replies||Last Post|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||2||November 25, 2012 09:54|
|Layers:problem with curvature||giulio.topazio||OpenFOAM Native Meshers: snappyHexMesh and Others||10||August 22, 2012 09:03|
|rotating cylinder using sliding mesh||Tim Daly||FLUENT||1||November 10, 2008 00:02|
|ICEM block mesh with a ball in a cylinder tube||Li||CFX||6||August 11, 2008 05:44|
|mesh problem for cylinder||akr||FLUENT||1||January 30, 2007 00:43|