|
[Sponsors] |
[blockMesh] Tutorial for Creating Simple 3D Meshes |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 6, 2007, 17:05 |
Tutorial for Creating Simple 3D Meshes
|
#1 |
Guest
Posts: n/a
|
Hello, I am trying to simulate fluid flow around a cylinder and around a sphere. I am very new to OpenFOAM (and CFD in general), and needing to get some basic results fast. So I wanted to see if anyone could recommend a tutorial for creating spheres and cylinders. And perhaps a tutorial on how to run some simulations on the geometries I make. I looked over the tutorials on the OpenFOAM website, but nothing caught my eye that looked like it taught how to make 3D geometries; everything seemed geared toward 2D.
Thanks for any help you can give. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mapping (interpolation) between two meshes | Ebrahim | OpenFOAM Programming & Development | 2 | June 15, 2020 13:31 |
[Tutorials] New Dakota - OpenFOAM Coupling Tutorial | Tobi | OpenFOAM Community Contributions | 0 | October 9, 2016 17:19 |
How can I put the data of adpated meshes on the original unadapted meshes? | xh110120 | FLUENT | 2 | March 11, 2016 02:00 |
[PyFoam] Simple tutorial for exporting some PyFoam data (variable) to OpenFoam | Asghari_M | OpenFOAM Community Contributions | 0 | June 20, 2015 15:16 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |