|
[Sponsors] |
July 11, 2014, 17:39 |
STL file, Patch addition
|
#1 |
Senior Member
|
Hi everyone
I am bigener in CFD. I am using SALOME 7.4 for stl file, which I wanted to use in OpenFoam for snappyHesMesh. I wanted to ask How can I add different patches in stl file, e.g inlet, outlet and wall for a cylinder. For which later I could apply boundary condition in OpenFoam. Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] Installation Problem with OF 6 version | Aurel | OpenFOAM Community Contributions | 14 | November 18, 2020 16:18 |
what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 01:22 |
[foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
[OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
[swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |