|
[Sponsors] |
October 2, 2019, 11:55 |
create inlet and outlet
|
#1 |
New Member
Join Date: Aug 2019
Posts: 19
Rep Power: 6 |
Hi,
I need to create an inlet and outlet in final mesh (after a blockMesh-snappyHexMesh (.stl)). I tried topoSet followed by createPath with no sucess. My inlet and outlet are pipes (cylindrical shape) and my main body is a tank. Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] Create Sketches (Hub, Shroud, Inlet, Outlet) | tuete | ANSYS Meshing & Geometry | 3 | September 7, 2017 05:06 |
Pressure inlet vs outlet position, transient, time dependent pressure and gravity | silent2608 | FLUENT | 0 | February 6, 2016 10:19 |
Mass flow inlet and pressure outlet issue | nikhil | FLUENT | 5 | December 11, 2013 12:30 |
Inlet & Outlet Velocity BC issue | naiter | OpenFOAM | 3 | December 19, 2012 07:14 |
steam flow in a pipe driven by a pressure gradient between inlet and outlet | SalvoCalvo | COMSOL | 0 | March 11, 2010 06:52 |