 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] snappyHexMesh / surfaceFeatureExtract do not snap to edge |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 11, 2013, 14:22
|
snappyHexMesh / surfaceFeatureExtract do not snap to edge
|
#1 |
|
Member
Join Date: Oct 2012
Posts: 32
Rep Power: 13  |
Hi guys,
i think this topic must be boring for you, but i have some problems with snappyHexMesh:  The picture above shows a detail of the geometry which i want to mesh. The geometry is a STL-geometry-file. The same detail after snappyHexMesh detail looks like follows:  I extracted the edges with surfaceFeatureExtract, apparently with no success. Can you give me any hints in order to improve my mesh? Thank you very much in advance! |
|
|
|
|
| Tags |
| snappyhexmesh, surfacefeatureextract |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Failed Edge Snap with box geometry and correct feature capture | thiagomarinho | OpenFOAM Meshing & Mesh Conversion | 7 | May 7, 2022 09:19 |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [snappyHexMesh] snappyHexMesh doesnt snap | staustrahltriebwerk | OpenFOAM Meshing & Mesh Conversion | 47 | March 18, 2018 14:19 |
| [snappyHexMesh] snappyHexMesh failure to snap to geometry | Yadasol | OpenFOAM Meshing & Mesh Conversion | 1 | November 17, 2014 05:00 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Threaded Mode
