[cedric_duprat]

Hi all,

I'm looking for the "scalePoints" tool. In the user guide for OF 1.3, there is this tool which is suppose to "scale the mesh points in a polyMesh directory by a factor supplied as an argument".
I can't find it on OF 1.4.1 in the manipulation mesh directory.
This tool is not in OF 1.5.
So, is there a similar tool in OF 1.4.1 ? or maybe someone know how to do such thing whithout doing it by hand.

Thanks in advance,

Cedric


PS: I found a tool called "deformedGeom" but, it's using a displacement field U and after a few try, it doesn't seem to be effective for what I want to do.

[hani]

Hi Cedric,

Try transformPoints

Håkan

[cedric_duprat]

Hi Hakan,

Thank you, It's woking fine
... I had an old user-guide ....
maybe it's time to print a new one :-)

Cedric

[hani]

Hi Cedric,

I'm afraid that you should not rely too much on the UserGuide. It is not updated as fast as the code. For transformPoints, I think that it was mentioned in the release notes. At least I'm sure that you can find the answer already in the Forum.

Håkan

[cedric_duprat]

Thank you again,

You're right about the UserGuide but ... as I used to say, it's better than nothing :-)
And in the forum, I just found the same question from a 2005 thread by .... you that's why you are so sure :o)
http://www.cfd-online.com/OpenFOAM_D....html#POST4137

Thanks again,

Cedric

[hani]

Cedric,

I hope that you understand that this means that you must help someone else with this question in three years :-)

This is what the Forum is all about.

Håkan.

[cedric_duprat]

:-)

ok, I'll try not to forget ...
let's check in 3 years

Cedric