 |
 |
 |
|
|
|
[Sponsors] | ||||
May 9, 2012, 12:00
|
Sharp Edge
|
#1 |
|
Member
Join Date: Mar 2012
Posts: 51
Rep Power: 14  |
Hi all,
im having a problem in meshing a sharp edge. I used polydualmesh to convert a tet mesh. The case is 2D and polydualMesh creats automatically another cell layer in z-direction so that i had to remove this layer to get just one layer of cells using setSet. So far so good. everything worked , checkMesh looks good and everything is Ok. I just have one small problem near the edge when viewing the mesh with paraview... i dunno what this is (im not sure if its a cell). I attached a snapshot of the mesh . Any help would be appreciated. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [ICEM] Meshing Wing with low Y+ value and sharp trailing edge | sonic109 | ANSYS Meshing & Geometry | 0 | July 27, 2015 09:29 |
| [ICEM] Hole near sharp trailing edge of airplane/wing geometry | jlichtwa | ANSYS Meshing & Geometry | 2 | September 21, 2010 15:19 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Threaded Mode
